NB Quality Catalogue ENG 2020

31 30 Lock defreezer and lubricant nbq lock oil NBQ Lock Oil is a conditioning oil with defreezing properties for refined mechanisms. Its main components are refined oil, PTFE and alcohol. Due to the aforementioned substances it is possible to melt frozen mechanisms fast and guarantee their flawless performance in difficult conditions. General information NBQ Lock Oil is suitable for defreezing locks, wire ropes, pins and other refined mechanisms. NB! The product does not withstand high loads! • Temperature range for storing, transportation and use is +5 ºC up to +45 ºC. • Shake the aerosol properly before use. • If possible, clean the surfaces prior to application. • Press the nozzle into the lock or mechanism opening and spray. • If necessary, repeat the procedure. Base substances refined oil PTFE Colour clear Odour typical Temperature resistance -40 ºC up to +120 ºC Load resistance low Corrosion resistance medium Density 0,689g/ml • Melts and lubricates • Fast effect • Lubricates lock details • Easy to use Technical information Applications Instructions for use Product and accessories Product Package Code Short code Product group EAN code NBQ Lock Oil 50ml NBQ213005 L39 Lubrication 4742628001163 lubrication Thin teflon lubricating oil PTFE OIL PTFE Oil is a highly refined synthetic lubricating oil. The product car- ries extremely well and has a wide range of operating temperature. Due to its special composition the oil has small internal resistance and good load resistance (PTFE particles) also in the most extreme conditions. The product is harmless on plastic. Compared to Sticky PTFE Lube and PTFE Lube, the PTFE Oil car- ries considerably better and the product endures wider range of operating temperature. Stability and low internal resistance at sub- zero degrees are especially important. The product binds dust and dirt minimally. General information PTFE Oil is suitable for lubricating locks, sliding surfaces, refined mechanisms, wire ropes, bushings, bearings of roller-skates and hinges. These places of use are charac- terized by lower load than average, dusty environment and wide range of temperature. In exceptional cases it is suitable for dissolving rust. • Temperature range for storing, transportation and use is +5 ºC up to +45 ºC. • Shake the aerosol properly before use. Make sure before use that the surface is clean. • If necessary, clean the surface with Brake Clean. Spray the product evenly on the surface from 25 cm distance. • The product can be sprayed only if the aerosol is held in upright position. Let the solvent contained in the product to evaporate and then assemble the parts. Base substances PTFE powder, fully synthetic oils, antioxydants, anti-corrosion additives Colour clear, slightly yellowish Temperature resistance -55ºC up to +250ºC Corrosion resistance medium Load resistance average Load resistance-Shell 4 ball test 900 NM Water resistance medium Density 0,683g/ml Base oil viscosity at 40 ºC 31 cSt • Carries extremely well • Temperature resistance -55 ºC up to +250 ºC • Low internal resistance of the lubricant • Does not attract dirt • Good load bearing capacity Technical information Applications Instructions for use Product and accessories Product Package Code Short code Product group EAN code PTFE Oil 400ml NBQ220040 L33 Lubrication 4742628001071 Auxiliary products Brake Clean 500ml NBQ492050 C10 Cleaning 4742628000524 lubrication